Stem tension repair steps ①use the file to remove the burr at the burr; shallow parts of the injury, the use of flat shovel processing to a depth of about 1mm, and then polished with abrasive cloth or angle grinder, this time will be presented New metal surface. ② with TL-700 metal cleaning agent to clean the surface, the surface was repaired without oil, dust-free and no dirt. ③ wear wear repair agent. ④ detail trimming. Preparation and coating process of wear repair agent ①Prepare the repair agent according to the volume ratio of 3.8: 1; ② Apply the adhesive to the surface of the wound, the first pass should be as little as possible painted, coated from top to bottom, air bubbles are not allowed Exist; ③ After the first pass 1h (that is, after the initial curing adhesive), according to the requirements to re-reconcile the repair agent, the second pass, requiring higher than the original size of 1 ~ 2mm; ④ to be cured after 1h, With 80 ~ 100 ℃ iodine tungsten lamp heating 3h can. Detail finishing process requirements ①with a file, scraper and emery cloth and other tools will be higher than the original size of the adhesive removed, the operation should be measured at any time, do not make the glue layer is lower than the original size, and set aside 0.5mm as finishing integer; ② to be size When finishing the finishing, use the pre-processed grinding wheel to make the dressing (80 mesh emery cloth pad); ③ When the size is higher than the original size 0.2mm, replace the emery and grind to the actual size precision. Matters needing attention As a result of on-site repair, so in order to ensure the quality of the repair, the repair of the surrounding (especially the upper part of the dust, oil, etc. must be cleaned up; repair defects such as small pores, etc.) .
Tape Tensioner For Circular Knitting Machine
Tape Tensioner For Circular Knitting Machine,Tape Tensioner,Poly Tape Tensioner,Polytape End Tensioner
Changzhou Longfu Knitting Co., Ltd. , https://www.circularmachine.com