| Home>Bearing knowledge>Disposal methods and causes of overheating of motor bearings |
Disposal method and cause of overheating of motor bearing
Source: China Bearing Network Time: 2017-10-05
| /*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089'; |
7, the sliding bearing lubricant is too little, there are impurities or oil ring stuck. Should be refueling, new oil; repair or replace the oil ring.
2. The rolling bearing grease is too little, too much or has iron scraps and other impurities. The bearing grease capacity should not exceed 70% of the total volume; those with impurities should be replaced.
4. The bearing and the end cap cooperate too tightly or too loosely. The bearing chamber is processed when it is too tight; when it is too loose, the steel sleeve is set in the end cover.
6. The belt is too tight or the coupling is not properly installed. Adjust the belt tension; proofread the coupling.
5. The two caps or bearing caps of the motor are not properly installed. Install the end cap or bearing cap into the flat; tighten the screws.
3. The shaft and the bearing cooperate too tightly or too loosely. When it is too tight, it should be ground from the head; when it is too loose, it should be set to the shaft.
Recommend to friends comments close window
| Bearing related knowledge |
| The timing of the bearing view of the rolling bearing parts production process file from the smooth bearing will become the leading product of the bearing profession The influence of the oscillation and temperature of SKF imported bearings on the bearings |
This article links to http://
Please indicate the bearing network http://
Previous:The reason why the bearing oscillates and its damping method are discussed in the next section: Rolling bearing layout type classification
Circular Saw,Cordless Circular Saw,Electric Circular Saw,Portable Circular Saw
ZHENGYANG TECHNOLOGY CO.,LTD , https://www.supraone.com