Miniature high-pressure pump high pressure, small size, easy to carry, commonly used in cleaning, spraying, spraying, pressurization, etc. Now to say micro-pressure pump operating methods and precautions. Micro-pressure pump First, the micro-pressure pump operation 1, the pump and the inlet and outlet connections are good: you must ensure that the inlet and outlet pipes and pump connections close, otherwise it will cause low pressure or leakage; Tip: There is an arrow on the pump instructions The direction of the water into and out of the water, the arrow direction for the water, on the contrary for the water; 2, installed in the water inlet filter, the filter density required to better the 80 mesh or more (ie, 1 hole 80 holes); 3, Pump connected to the power supply: the electrical parameters of the connected power supply must comply with the input requirements of the motor; 4, the power is turned on, the motor pump starts to run; 5, the water 5-10 seconds, drain the air inside the pump and the pipe, After stabilization, temporarily turn off the power, connected to the water gun (or similar tools); 6, turn on the power to work properly. Second, the use of miniature high pressure pump Notes 1, do not use the temperature exceeds 70 ° high temperature water or dirty water (dirty water in the sand will cause irreparable damage to the pump); 2, the motor pump can spill a small amount of water 3, the motor pump can not be placed in a humid place for a long time; 4, do not disassemble the machine or adjust the pressure on their own Set the screw (without adjusting the pressure setting screw, the pump may be fatal); 5, it is strictly prohibited to use the machine without the filter, the filter density is best in the 80 mesh or more (impurities will give the pump Damage caused by injury); 6, the diameter of the spray hole must meet the required value, otherwise it will damage the motor pump; 7, household use only, not for commercial use (to avoid overheating and reduce the service life, Intermittent work); 8, confirm the power supply before use, the power supply parameters and the motor pump input parameters consistent; 9, recommended supporting power line should not be thinner than 0.75 square (copper wire), length of 2.5 meters, should not be too long fine. If you really need to lengthen, you need to lengthen the diameter of the bold at the same time, otherwise it will be due to the power line pressure drop is too large, resulting in reduced output performance of the motor pump (the thicker the better, the shorter the better, the length can be enough) ; 10, the proposed pipe diameter should not be less than ∮ 5.5, the length should not exceed 10 meters (not too long and too fine, or affect the pressure flow and gun effect. (The thicker the better, the shorter the better, enough to use); 11, it is recommended that the inlet pipe diameter is not less than ∮6, self-priming water inlet pipe length should not exceed 1.5 m (the rougher the better the shorter the better); 12, tap water and other pressurized water source, you can properly lengthen the inlet pipe Water pressure shall not be greater than 0.1MPA (1 kg force); 13, after winter to be drained pump and piping water, or easy to freeze the pump (usually do not drain the pump water, cover the inlet and outlet cover); 14, using 220V mains power supply, the movie adapter connected to the power circuit must be equipped with earth leakage protector; 15, the power cord damaged by professionals to repair or replace; 16, battery power supply, beware of the battery loss Electricity; 17, a long time do not need to use or suspended please stop The connection between the pump and the motor power supply Further Reading: pump valve pipe fittings Exhibition Water Expo Xiamen exhibition of marine equipment Internet + Forum Yiwu Fair 2016 exhibition mold top ten brands of the Internet information industry (Xiamen) Technology Co., Ltd. Author: Asia Pump Network Editor: Yao Xiaoxia (QQ / WeChat:) http://beng.liuti.cn/ (Service Hotline:)
Smart Faucet,Smart Faucet Price,Smart Faucet Product
Yuyao Zelin Sanitary Ware Co., Ltd , https://www.kitchen-sinkfaucet.com