At present, some users do not care much about the quality of the balcony's packaging, and even think that the quality of the balcony is less than that of the living room. Therefore, they randomly found some migrant workers to manually install, thus buried potential accidents.
If you compare the aluminum windows on the balcony with the equivalent doors and windows in the home, it is clear that the quality requirements of the former are much higher than those of the latter. Because the balcony is volleyed on three sides, the wind is blown on several sides, and its force is much larger than ordinary windows. In addition, many balconies were designed without regard to the future packaging of the balcony. At the top of the balcony and the guardrail, there was no place where the window sash “restedâ€. Therefore, accidents can be easily caused by poor installation. So, if you decide to close the balcony with aluminum alloy windows, in addition to those noted above, you need to pay attention to the following aspects:
1, can not use small sections and thin-wall aluminum aluminum balcony window. Some construction teams cut corners and use aluminum tubes instead of regular aluminum window profiles. This will greatly reduce the capacity of aluminum windows in balconies. If you encounter strong winds, distortion, deformation, or even shedding will occur.
2, aluminum strength must meet the standards, ultra-coded when hand-folded should feel very hard. Soft material can not be used firmly.
3, the design should be reasonable, not for the provincial material to take a big grid approach. It is not possible to use a large sash from the guardrail to the top to “floorâ€. Be sure to install a 400- to 500-mm fixed window in the upper part and a 1200- to 1300-mm sash window below. Moreover, the sliding window should not be too wide.
4, taking into account the aluminum alloy frame can not be too much force, the closed balcony is generally not using casement windows.
5, fixed to be solid, balcony aluminum window frame and horizontal frame must be fixed on the balcony of the guardrail and the top, with a shot nail and rivets fixed in the concrete, and then reinforced with painted steel angle. Can not be fixed on the brick wall, but also can not use the wooden wedge up and down the vertical frame instead of nail gun fixed.
6. The high side of the glazed sliding window of the aluminum window should be indoors and the low side should be outdoors to prevent infiltration of rainwater. A small hole should be drilled on the outside of the lower edge to eliminate rain. All voids in enclosed balconies should be completely filled with cement mortar.
Balcony space effect picture window aluminum alloy space home paint fashion small size
Drop-in kitchen sinks, also called self-rimming sinks, overmount sinks, or top-mount sinks, are sink basins that install and sit on top of your kitchen counter. There is a visible rim or lip on the perimeter of the basin that rests just over the cut-out for the sink. Drop-in sinks are supported by this lip and a series of hidden clips that attach to the underside of the countertop.
The Advantages of Drop-In Sinks
Drop-in sinks have some clear advantages over other styles, especially in the kitchen.
Cost
They`re generally cheaper to buy and easier to install than undermount sinks. In fact, even weekend warriors and DIY newbies should have no problem installing a basic overmount sink. If cost is a consideration in your kitchen, an overmount sink with a do-it-yourself install is a great way to stay within budget.
Cleaning
While cleaning may not be your foremost concern when choosing a kitchen sink, it should be considered. After all, you`ll have to care for and maintain your sink regularly. The basin of an overmount sink is easier to clean than the basin of an Undermount Sink.
Protection
If you`ve got soft countertops, drop-in sinks can help protect the edges of the sink cutout.
- Marble and some specialty counter finishes benefit from the added protection provided by the lip of a drop-in kitchen sink basin. It prevents the build up of water on the surface edges of the stone through repeated exposure of use.
- If you have laminate countertops, drop-in sinks are the only option: the particle board below the laminate surface isn`t strong enough to support undermount sinks but plays well with self-rimming basin types.
Top-Mount Sinks,Top Mount Kitchen Sink,Top Mount Stainless Steel Sink,Black Top Mount Sink
Guangdong Huayou Hardware Products Co.,Ltd , https://www.gudsink.com